Yesterday evening, I was able to work on one of the three raised beds in the south east yard, where we grew popcorn this year. Aside from weeding and preparing the soil for next year, I wanted to see if I could do something about the bowed out sides.
In the first picture of the slide show above, you can see I had a line across, already. That was enough to keep it from bowing out more, but not to pull it in. For that, I needed to move the soil more than I had, when I put the line in, in the spring.
The first thing to do was dig through the entire bed, removing all the weed roots I could. Once that was done, I shovelled soil away from the side walls, then redid the line. The original line actually broke while I was working with it, so I brought the roll of mason’s line and did it again. This time, instead of just doubling the line, I took used enough to fold it three times, making for 8 strands. After opening up the metal thing I can’t remember the name of, I put the lines on and pulled the sides in. One side was worse than the other (on the left, in the photos), so I focused on that one more.
Slight problem, though.
This is built out of scrap wood I found in the barn. One of the corners was already deteriorating more and, when I pulled the side in, I think I snapped the screws in the top board!
The corner is still holding, though. I’ll add more screws later.
Once the line was secured, I also tightened the metal thing (why can’t I remember what it’s called?? š), using a nail for leverage. That pulled the sides in a little more, too. I didn’t want to pull it in too much, though, because things would start breaking.
The next step was to level the soil again. By that time, I was losing light, too. To get a good idea of how well the sides had been straightened, I took the cover off the carrot bed, which isn’t needed there, and popped it over the prepared bed.
I had to come back today to get a picture, though, because the one I took last night did not turn out in the low light!
All these beds, and all the covers, are 9′ x 3′ (technically, 9′ 1″, counting the width of the end pieces). Which means the covers should fit exactly over the bed frames.
Well… it almost does!
The side walls now match the sides of the cover, but the corners, not so much! The corners on the bed have shifted. The one that broke is actually lower than the others, too! No surprise, considering there was so much flooding in the paths last year. However, it’s all close enough that it doesn’t matter much.
So this bed is now ready for next year’s garden!
Now, if we can just get to the others, and finish the trellis beds, before things start to freeze. Today is supposed to be the last rainy day for a while, so I should be able to break out the power tools and extension cords again. Current forecast also calls for lows of 1C/34F, 2C/36F, 1C/34F, then -1C/30F, over the next few days. Which means that, tomorrow, we need to either bring in the last of the stuff outside that isn’t frost hardy, or cover them for the night. Tonight, at least, is only supposed to go down to 6C/43F. We’re also supposed to get more heavy rains. Right now, it’s a damp and chill 12C/54F.
I’m glad we got the septic tank done yesterday, that’s for sure!
Lots of work to do out there, and time is running out. It all comes down to the weather.
The Re-Farmer
The Re-Farmer 