Today, my goal was to at least plant the melons in the main garden area. Before I could do that, however, the bed needed to be prepared.

Not the soil, though. That was already done.

The frame that never got fully assembled last year.

First, though, I had to be able to access it, which meant using the corded weed trimmer, so I had to wait until everything was dry enough from this morning’s rain.

After weeding the bed earlier, I covered it with plastic to keep out windblown seeds, cats and hopefully bake any new weeds that tried to come up. Considering the paths were so full of dandelions in full seed, I was glad of it!

I did pause while I was doing that to check on the carrots. I’d seen some starting to come up yesterday, but with how hot it was expected to get, I left them covered to keep them moist and cool. Today, I took the boards off and set them on the sides of the bed to protect the soil from erosion and digging cats.

For the frame, all I needed to do was attached the 4′ ends to the sides. I debated between attaching them to the ends of the logs, which would make the beds slightly longer, or to set them on top of the logs. I decided to set them on top.

The first step, after moving the 4′ logs away, was to move the soil away from the ends to make space. Then the end logs were lined up with the sides logs, so I could use the width of the side logs to make a stop cut for the section that I needed to remove. The first one worked out pretty good.

Once the sections were cut out, I set the log on the sides and used it to make stop cuts on the side logs to match the width of the ends.

From there, it was cutting away enough wood that, once the end log was in place, the top would be about the same height as the side logs. That part took a bit more fussing and more removal of material.

Once it was done and the end log was in place, there was quite a gap under it. I used the bits and pieces of wood that was cut off to fill the space, rather than just fill it with soil. I didn’t want to waste good soil!

Then I repeated the process on the other side.

Which I did a really crappy job on! But, they fit together, and that’s all I really needed! Once again, the scrap bits of wood were pushed under the log at the end to fill in the space, before the soil at both ends was leveled.

The whole thing was more of a pain then it should have been, but it is what it is!

The only thing that needs to be done now is to drill holes through the corners, then drive a rod through to secure the logs together. Right now, the end logs could get knocked of fairly easily.

In time, more logs will be added to make this bed taller, but for now, the priority is to frame all the beds and make the new trellis beds. In time, I hope to make all the beds about 4 logs high (assuming logs the same size as now). That’s what the high raised bed is, and I’m finding that height ideal to work with.

It’s going to get a few years to get to that point, though! There’s only so many dead trees we can harvest for this. That and having nice, straight 18′ lengths for the sides is not as easy as you’d think!

This one, however, is finally done!

It only took about a year… !!!

The Re-Farmer