Still going!!

Good grief.

My new computer still isn’t set up.

Yyo.  I’m still blogging with my phone.  Please forgive any typos I miss!

With the constant restarting, followed by the screen saying to check our Wi-Fi, and no way to bypass it, we tried something different.

My husband had suggested setting the computer up in the living room, where the Orbi signal boosting device is located. 

There was no way I was going to haul everything over to do that.

So,,my husband brought the device to my room, instead.

The risk of that is twofold.  One, the log walls of my room could affect its ability to improve signal to other parts of the house and two, my room is not a cat free zone.  The risk of the device being pulled down, knocked over, etc. was much higher.  We ended up setting it on the top of my wall shelf, so it’s now just the power cord that needs to be watched out for.

Did it work?

Well… sort of?

We dud a hard shut down to set things up.  When I turned it on again, it went back to where it left off – this machine behaves as if it was in sleep mode, rather than powered down  – when through the first part of the loop, got to the “Just a moment…” screen…

…and stayed there.

I left it and went to bed.  Of course, I couldn’t sleep, so I checked it frequently.   No change.

I finally fell asleep, and when I got uo this morning, there was still no change!

I went to do my morning rounds, and when I got back, there was finally a change.

It was off.

I turned it back on, and it went straight to the “Just a moment…” screen.

Then it restarted.

Since then, it has restarted itself and gone through the loop 5 or 6 times in the last hour.

I dud call the customer support number, but they aren’t open in California, yet.  I left a message, asking for a call back.  With the time zones, they won’t be open for almost another hour from the time I’m writing this.

What I hope is happening is that the computer is finding updates, downloading them, installing them, then restarting.  After restarting, it finds another update, and goes through the process again.

The problem is that “Why did my PC restart?” screen.  That screen is always part of the loop, which tells me there is a Wi-Fi problem.

Also, there is no other information.  No download status bars.  No installation status bars. Just “checking for updates” followed by “just a moment…” and then the restart. 

I would expect it would take a while to find , download and install updates.  I have NEVER had it take this long.  We’re at almost 20 hours of this, at the time I’m writing this post.

It’s gotten to the point that I am considering setting up my old computer in the l8ving room and using the TV as a monitor.  We have spare keyboards, though not ergonomic ones, and I’m using the new mouse on the new computer, so the old mouse is available.  I just don’t know if we have a spare HDMI cable to attach the TV as a monitor.  My husband might have one.

Oh, look at that.

The computer is restarting itself again.

*sigh*

Meanwhile…

Temperatures have been dropping since yesterday after, and a light snow started.  My highway conditions group has been very busy.   Everything is incredibly slippery, with several reports of vehicles in ditches, and at least one very major accident.   People were reporting the need to drive at very low speeds, and advising others to stay at home, if at all possible.   The high winds were causing many problems, too. 

This morning, the snow had stopped where we are, and there was only a light layer on top of the frozen slush.  I’m very glad we don’t need to go anywhere today.  I hear the sand crews are out, so when it’s time to go to the vet with 5 cats tomorrow  things should be safer. I still plan to leave very early, and expect to be taking it slow.

I counted about 30 or 31 cats outside, this morning. Nineteen, just in the sunroom.

Driver, here, is still not using that front leg.  It doesn’t stop him from jumping up to the cat house roof, though!  I am really unhappy that we can’t take him to the vet.

After he ate and seemed to want attention, I picked him up and cuddled him fir a bit.  He was nervous, so I took him into the shelter of the sunroom and gently put him down.

Which, for some reason, caused all the other cats to explode in all directions, which also caused Driver to panic and bolt out of the sunroom, then squeeze his fluffy bulk under the kibble house. 

I have no idea what trigged all that!

The ground under the kibble house is coveted by a sheet of rigid insulation, with another under the floor panels above, so that’s a good spot for cats to be.  He was still under there, when I finished my rounds.

Tonight, we will grab that fluffy tortie and bring her inside for her overnight fast.  Hopefully, in the morning, Sad Face will be around, and we’ll be able to get him in the big carrier.  The carrier is already in the sum room, so the cats are used to it.  If we can’t get Sad Face, there are many friendly males we can bring in, instead.

I have a sinking feeling, though, that if we bring that fluffy tortie in, we won’t be able to let her outside again.  She will need more recovery time than a male, and with the sunroom bring used as winter shelter, it’s not available as an isolation ward.

Unless the Cat Lady is able to take her.  The rescue is paying for three of the five cats.  She thought the tortie might be easier to adopt, but I don’t know if she got any responses, or was even able to share the picture.   I’ll have to ask her about that, today.

We shall see.  It would be good if all three littles went off for adoption, rather than coming back here!

I cam dream, can’t I?

The Re-Farmer

5 thoughts on “Still going!!

    • I have no idea. We finally took it off when we set the Orbi device up in my office, since they won’t both work at the same time.

      I just checked our Starlink stats. We did have a couple of “network issue” outages at around 1:30am. The longest was 21 seconds. I was still up, then, and the outage did not cause the computer’s “just a moment…” activity to fail. The computer did not restart itself all night. It was only after I found it shut off and turned it on again, that the loop began again.

      Possible cause: the computer spent the night downloading and updating to Windiws 11, then shut itself down. Now, it’s finding other updates and restarting itself after every installation, some of which are talking longer that others. The “why did my PC restart?” screen may just be their default screen before moving on to the next update.

      At least, that’s what I hope is happening.

      Excuse me, while I now -once again – go through the country, language, etc screen. At least the computer remembers my answers, and I just need to hit next.

      Liked by 1 person

Leave a comment