As I was finishing my morning rounds, I decided I had to get that cover off the high raised bed and move it to the old kitchen garden. The snow is still deep in the main garden area, but the bed in the old kitchen garden I want to set it on is already almost snow free.
Getting to the high raised bed was not going to be easy. I had to break a path in – literally! With the thaw/freeze cycles we’ve been having for the past while, the surface of the snow is hard, but not hard enough to hold much weight. I had to stomp my way through, breaking the surface layer, until just before I reached the high raised bed, where the surface was solid enough that it actually held my weight.
There was no way I could carry the raised bed cover while making my way back, though. My balance isn’t that good anymore! Thankfully, that wasn’t really an issue.
I could just slide it across the snow!
That worked out quite well!
Once I was clear of the deep snow, I could carry it normally. This cover, made using fence wire that needed to be sandwiched between two boards to secure it, is probably the strongest of all the covers I made.
If you click through to the next photo, you’ll see that the cover almost perfectly fits over the bed in the old kitchen garden! Which wasn’t at all intentional. When we first planted in this area, the bed was more triangular in shape. It was too wide at one end to reach the middle easily, so when I used logs to make it into a higher raised bed, I made it rectangular, but just worked with the space I had. I don’t think I actually measured anything. The covers are all 3′ wide by 9′ long. At one end, by the rose bush, it fits perfectly between the vertical corner supports at that end. The end closer to the house is slightly wider, but not enough to be an issue.
The challenge is going to be, how to cover it with plastic. Not only does it need to keep the cats out, but it has to be secure enough that the wind won’t blow it away.
There are gaps around the sides and one end of the bed that a cat could potentially squirm through. Which means my original thought of somehow securing the plastic directly to the wood frame itself is not going to be good enough. What I might be able to do is have the plastic go on the outside of the bed and secure it into the path in some way that would allow me to lift the plastic to tend the bed, as needed. How to keep it from being blown loose by the wind is going to be the main issue. I know that simply using ground staples to pin it in place won’t be enough. The wind would tear the plastic free in no time.
We have small logs from when the branch piles were chipped, each about 4′ long, stacked beside the wattle weave bed. I may just use some of those to weigh down the edges of the plastic, all along the outside of the bed. It will take several sheets of the plastic I have, though, and those will need to be taped together with clear tape. I’m definitely going to need to get a daughter to help me out with that, because I know the wind is going to make that job quite difficult!
Before we secure it, though, I’m going to see if I can remove the mulch, then add more snow to the bed before covering it with plastic. The melting snow will help “water” the bed. The mulch might still be too frozen, though. If so, we’ll put the plastic over it for a day or so, which should thaw things out faster, then try again.
If this works out as I hope it will, that will give this bed a head start. This is the bed that has:
– spinach – four different varieties
– Swiss chard – two different varieties
– Shallots and onions – saved seed
– Kohlrabi – both purple and green
– Hedou Tiny bok choi – saved seed
There are a lot of older seeds in this mix, so it’s hard to know just how many would germinate, even if they did survive the winter.
Well, this is an experiment, so whatever happens, happens!
The Re-Farmer
The Re-Farmer 