Okay, I got some good progress today!
My first goal was to “pot up” the onions in their seed snails. For this, I wanted to use potting soil, rather than more seed starting mix. I have a bag of potting soil from last year with plenty still left in it, but I knew it was really full of sticks. Which meant I needed to sift it, first, because there was no way it could be used in the snail rolls as it was.
I got out a bucket and a colander that I use for harvesting in the summer, and started sifting in batches. The potting soil was bone dry which made it easier to sift, but also meant there was a LOT of dust. Even misting with water didn’t really help much. I did try to use a dust mask, which is difficult all on its own, since I can’t wear masks anymore. It was either breathing dirt without it, or struggling to breathe with it. Definitely a no-win situation. It didn’t actually help much, to be honest, but it was better than nothing.
I was blown away by just how many sticks I sifted out.
That pile on the side? That’s what I sifted out of what you see in the bucket. I poked my finger in to measure, and it was up to my second joint, so about 2 inches deep. Good grief! It was almost more sticks than soil!
The next step was to moisten the sifted potting soil. I used hot water for that, so it wouldn’t be a shock to the plant roots. It took a remarkable amount of water to moisten it, and I was just aiming to get it wet enough to be able to stick to itself.
Then it was time to get the onions ready.
This is how they looked to start with. These rolls all fit into one bin, and the seedlings are looking pretty good.
The length of them did make unrolling the snail a bit of a challenge! They were tangled together, and wanted to twist around each other as I unrolled the snail.
In the first photo above, I unrolled the first seed snail. These were bottom watered, and you can see that the soil is moist all the way through, and the roots are all the way to the bottom. Some of them seemed a bit crowded, so I did adjust a few of them to space them out a bit. In the second picture, you can see where I’ve added the potting soil on top. From there, it got rolled up and taped closed again.
It was a lot bigger, of course. Only two could fit in the bin I was using, but I did have a second, slightly smaller one, available.
Here are the “potted up” onions. In the second picture, you can see that one of the snails is a lot smaller. That’s the bunching onions. It’s a good thing those didn’t need as much soil, because I was scraping the bucket to get every last bit out for that roll. I really didn’t want to have to sift more!
These are now back in the living room. They are the only things I have space for there, this year.
In order to do this, I had to completely clear my work table. That meant taking away the trays, lights, heat mats, and everything under and around them.
With the onions done, I could then arrange the work space to be ready for the next batch of seed starts. I have the top shelf from a plastic shelf that was too tall to fit in the old basement, and it was used last year to hold trays higher up. That’s what I am using it for again now.
My poor little peppers and eggplant.
Hopefully, the new seeds I sowed yesterday will germinate – and won’t get eaten! I had some concerns about not having heat mats under them anymore, but before I set up the shelf, I made sure to create a wall of cardboard around the back and at one end, then moved the heater so that it was blowing under the shelf. That made a big difference, and the warmth is kept under the shelf enough to warm the trays from below. Not that the heater is on all the time, but even when the furnace is on, now that the opening between the basements is uncovered again, there is heat blowing in and the cardboard, etc. holds it around the plants surprisingly well.
Which you can see better in this next picture.
The insulation leaning at one end it just there until it’s needed later; the cardboard forms a “wall” behind it, out of frame. I’ve got the flaps of the cardboard box under the back legs, so I had to put something under the front legs to level the shelf. Then I set up the insulation pieces, which protect the cutting mat from warping, and the heat mats, ready and waiting. With the seedlings so close to the shop light, the plant lights aren’t needed for now, so they’re just clamped to the table in the front. There is no place to clamp the lights to use them on top of the shelf, anyhow. Everything gets plugged into a power bar with USB ports that I have set up above my work table.
As for our next seed starts, I don’t think I’ll be using the seed trays again. They are all smaller seeds, and for the space, I think I will do more seed snails. I wouldn’t me making them as deep was what I used for the onions, though. More like a third of that height. I have lots of that packing foam available.
I need to remember, though: do not use painters tape to attach them together to make a longer strip. One of the onion rolls started to split at the tape while I was rolling it back up again. It doesn’t like moisture. I’ll have to see what alternatives we have.
That won’t be needed for another week or so.
For now, I’m just glad I don’t need to sift more of that potting soil for a while!!
The Re-Farmer
The Re-Farmer 